tulrich
10-12-2005, 09:28 PM
Greetings all! I'm having some weird issues with bluetooth connectivity between my HP 2215 (ROM 1.10) and Sony Ericsson T616 phone (firmware R1B027).
I can:
- pair the devices just fine, with either the phone initiating the pairing or the iPaq.
- browse files on both devices.
- transfer files between devices.
- send a phone number from the iPaq (using Agenda Fusion) to be dialed on the phone
However, I can't:
- establish a serial port connection from the iPaq to the phone
- establish a DUN connection from the iPaq to the phone
In both of these latter cases, I get the same error on the iPaq: "Unable to establish a connection. Please make sure the device is enabled and in range. Also verify that the requested service is available." Well, the bluetooth radio in the phone is on, and it's sitting next to the iPaq. And both serial port and dial-up networking are on the T616's bluetooth services list.
What I've tried so far:
- soft-resetting the iPaq
- turning iPaq bluetooth off, soft-resetting the iPaq, turning iPaq bluetooth back on
- turning phone bluetooth off, then back on
- turning phone bluetooth off, then turning the phone off and on, and reactivating phone bluetooth
- deleting the pairing on both devices, then re-pairing the devices with the iPaq as the initiating device
- deleting the pairing on both devices, then re-pairing the devices with the phone as the initiating device
Having searched the posts here and at HowardForums, I can't find anyone else who has had this particular problem. And I'm stumped.
Any thoughts?
I can:
- pair the devices just fine, with either the phone initiating the pairing or the iPaq.
- browse files on both devices.
- transfer files between devices.
- send a phone number from the iPaq (using Agenda Fusion) to be dialed on the phone
However, I can't:
- establish a serial port connection from the iPaq to the phone
- establish a DUN connection from the iPaq to the phone
In both of these latter cases, I get the same error on the iPaq: "Unable to establish a connection. Please make sure the device is enabled and in range. Also verify that the requested service is available." Well, the bluetooth radio in the phone is on, and it's sitting next to the iPaq. And both serial port and dial-up networking are on the T616's bluetooth services list.
What I've tried so far:
- soft-resetting the iPaq
- turning iPaq bluetooth off, soft-resetting the iPaq, turning iPaq bluetooth back on
- turning phone bluetooth off, then back on
- turning phone bluetooth off, then turning the phone off and on, and reactivating phone bluetooth
- deleting the pairing on both devices, then re-pairing the devices with the iPaq as the initiating device
- deleting the pairing on both devices, then re-pairing the devices with the phone as the initiating device
Having searched the posts here and at HowardForums, I can't find anyone else who has had this particular problem. And I'm stumped.
Any thoughts?