Log in

View Full Version : PocketMap Navigator and Navman 3450 sleeve


GeoGoGo
02-25-2005, 02:18 AM
Hi All,

I am having a problem and I was hoping someone could help me out. I have an IPAQ3955 with a Navman 3450 sleeve. I have purchased PocketMap Navigator software as I am not very happy with the Navman software.

With the PocketMap software, it scans for and finds the gps receiver. It sometimes picks up 8 active satellites but there is no signal indicator or signal bars. I have let the car sit in an open parking lot with a clear shot at the sky for over an hour. Still can not get an signal bars.

If I switch over to the Navman software, it gets a fix in two minutes. I have gone through all the troubleshooting and FAQ's on the PocketMap and Navman sites, followed all the steps in the PocketMap manual to no avail. I have sent off e mails to the respective companies support sites and am awaiting a reply.

I will put the specifics at the end of this post if it can help anyone. Any help you can provide me with will be greatly appreciated.

IPAQ 3955
Navman 3450 sleeve
driver: 2.3.7
com port: 6
baud rate: 57600

PocketMap Navigator
ver R3.12.204


Respectfully,
George D.