Cannot display 'AP Browser' when using WiFi card

[Gareth Lock]

Hi,

I have just purchased a Sandisk SD Wifi card and installed the drivers via Active Sync and have tried to connect to my network but to no avail.

When I click on the WiFi icon in the 'system tray' there are all the options available except 'AP Browser'; this is greyed out.

If I go through Connections and view Network card my home Wifi network is detected and show available but if I go back to Wireless Network Status from the desktop it does not have the correct channel or an IP listed although Associating is shown on the 'State' bar.

I have (temporarily) disabled all security on my ADSL NetGear Router and made sure it is detecting b & g wireless. The router does not pick up the Wifi card. I have tried manually entering the MAC address in the router but again no joy. I have tried inputting the IP address of the router into network connections again no joy.

How can I get this to work? I have downloaded the latest drivers from SanDisk, installed the SDIO update, have ROM 1.10

Thanks for your help

Gareth
www.imagesoflife.co.uk

[thunderck]

have you tryed to enter the SSID of the AP into your PPC?

[Gareth Lock]

I can now get the Wifi card to be detected by the router and I have connection but when I run WinC I cannot get the card to be associated despite the fact that I have both WEP and MAC working and a padlock shows in WinC.

If I click-hold and select Connect it wont....

Gareth
www.imagesoflife.co.uk

[thunderck]

Turn off ALL security on your router AP and broadcast ssid see if it works then and then start working backwards back to your current config.