VPN to corporate server and Terminal service client

[zipper]

Anyone has a working configuration for

1. VPN to corporate server and then
2. Use terminal service client to connect to servers?

I am using WM2003 and using Windows 2000 Pro's RAS server for remote access.

I am able to connect using my notebook computer so remote access is not a problem itself.

I was able (i think, as i can't see the duration of my VPN connection but I saw a connection in my RAS server) to connect to my VPN server and then I can do nothing, can't connect to server using terminal service client (in fact, it tried to connect again!!), can't connect to my intranet server using IE....

I had configured both Bluetooth Settings and My Work Network for Internet and Private network respectively.

My VPN configured in My Work Network.

My Network Adapters is always connect to "Work" and when I changed it to "Internet", soft reset and checked again, it is at "work" again, it seems I can't change this setting.

Inputs appreciated.

Thanks and regards.

[zipper]

Further check on the IP addresses when VPN connection is established (i think):

On Bluetooth Modem:

IP : 10.250.247.101
Subnet : 255.0.0.0
Gateway : 10.250.247.100

On RAS VPN Line 0

IP : 10.100.5.65
Subnet : 255.0.0.0
Gateway : 10.100.6.64

Could this be the conflict of IP addresses that make it impossible to reach my internet server that have the IP 10.100.50.100 (at another VLAN, which is reachable if using notebook)?

Any feedback appreciated.

Thanks & regards.