Pocket Street 2003 doesn't work on iPAQ 1940/2210 new firmware 1.10 ?

[moso]

Once I upgrade iPAQ 1940/2210 to their new firmware 1.10, MS PocketStreet 2003 doesn't work anymore for me. It simply freeze on load and need a software reset. Can anybody confirm this problem?
HP support sucks. Support told me that my 90 days warrenty is out and leave me in the cold.

[Deltrevan]

I had this exact same problem. I reinstalled Pocket Streets, and that fixed the issue. It's been fine since then.

[moso]

After I upgrade to firmware 1.10 that goes through hard-reset, it's already a clean new install of PocketStreet 2003. I did try to reinstall it again but no better.
Do you install to RAM or SD Storage Card ? Is it your second install that start to work?

[joakist]

how do you do a "hard-reset" ?

[Darius Wey]

how do you do a "hard-reset"?

hold down the power button and push the little reset thing with your stylus simultaneously and hold for a couple of seconds then release....if it doesn't work, it prolly means you weren't pressing the power button hard enough or pressed it at different times, so keep trying.

[Steven Cedrone]

how do you do a "hard-reset" ?

http://www.pocketpcthoughts.com/forums/viewtopic.php?t=25724&start=0

:wink:

Steve