terrypin
09-28-2003, 07:44 AM
I recently installed a trial of AlarMe from Epen Software. But after setting an alarm and powering off, my 2210 did nothing at the appointed time. This in itself was nothing particularly unusual, as I'm getting similar behaviour with other alarm progs, and of course the internal ones. But in the case of AlarMe, I was then unable to power up my PPC. Had to soft reset. Interestingly, the alarm sound and display then appeared during the boot-up.
I repeated with identical results several times. So far no reply to emailed support request to Eppen.
Anyone else had similar behaviour please?
Hope it can get sorted quickly, as otherwise AlarMe looked good to me on first impression.
Newcomer to PPC, Using iPAQ 2210 with WM2003.
--
Terry, West Sussex, UK
I repeated with identical results several times. So far no reply to emailed support request to Eppen.
Anyone else had similar behaviour please?
Hope it can get sorted quickly, as otherwise AlarMe looked good to me on first impression.
Newcomer to PPC, Using iPAQ 2210 with WM2003.
--
Terry, West Sussex, UK