First steps for T-Mobile BT phone paired with ipaq 2210?

[FlyPenFly]

I ordered a R520M and was just wondering what the steps are in pairing my phone with the PocketPC to get Data to work. I have T-Mobile unlimited data.

[SHoTTa35]

just turn on BT on the device and then search for phone devices (the 2215 has the option in bluetooth manager) and you're good as golden. It'll find each other, put in a key on the ipaq then put in the samekey (use numbers) on the phone and they are paired.

Now whenever you are ready to use the GPRS (BT on on the phone too of-course and after setting up your connection in the "connections" folder) Tap the icon beside the Time/Speaker and you'll see your GPRS number (for AT&T is *9***1# so something similar, get the number off T-mobile's site) Tap the number and it connects and in 3-5 seconds you're ready to go :D

[hollis_f]

just turn on BT on the device and then search for phone devices (the 2215 has the option in bluetooth manager) and you're good as golden. It'll find each other, put in a key on the ipaq then put in the samekey (use numbers) on the phone and they are paired.

Hmm. I've not used an R520 but I'd be surprised if it's not the same as other Ericsson BT phones in that you'll need to put the phone into 'Discoverable' mode for this to work.

[codesmith]

Nightline reposted this over at PocketPCPassion.com, i used these settings and have had great success connecting via BT phone to GPRS....
I will repost them here, hope it helps.

"Found the answer over at PocketPC Thoughts and figured I would post it here. All Credit goes to a guy named Jeffrey... and I quote...

I have the 2216 and a Nokia 3650 that communicate well (finally)...

My config:

1. Use the Bluetooth Manager and create a new connection. Select Connect to the Internet...
2. Select the Connect via a dial-up device...
3. Select your Nokia 3650 by clicking in the device box.
4. Follow the rest of the steps to completion.

5. Click on the Connections icon in the task bar and hit the settings. You should have a screen popup that says Bluetooth Settings. Click the Manage Existing Connections link.
6. Under the Modem tab, you should have a link for your dialup connection that you created in the bluetooth manager setup. Edit it.
7. On the first screen that pops up, make sure that Bluetooth Dialup Modem is selected and hit Next
8. For T-Mobile and the 3650, use *99# as the phone number (and don't use dialing rules).
9. On the next screen, leave the Username, Password, and Domain entries blank for now. Click the Advanced Button.
10. Set the following parameters:
Baud Rate: 115200
Select Wait for Dial tone before dialing
Extra Dial-String: +CGDCONT=1,,"internet2.voicestream.com"
Unselect Cancel if not connected in x sec.
11. Click OK to exit...
12. Click Finish to exit the Edit Connection Screen.
13. Hit OK to end the Bluetooth Settings screen.
14. Hit OK to end the Connections Screen.
15. Click on the Connections icon and then select the *99# link to dial your connection.
16. When prompted, erase everything in the Username, Password, and Domain boxes and then click the remember password option.

At this point, everything should be working. Note that if you are on the VPN plan, internet2 should be internet3. I am in Southern California, I had to use wap.voicestream.com for mine to work"

[FlyPenFly]

It keeps asking me in the pw/user screen for something and no matter what combo i try the connect always fails. i've tried saving pw, I've tried just hitting ok, i've tried it with i tall clear.