Hoping for some SD slot advice on HP 2215

[TheBadCzech]

Ok, this is my first PPC that has an SD slot so I'm not very familiar with it...please forgive my noobishness. I would like to pick up an SD memory card to gimme lots o' capacity. I have an HP 2215. If I buy one of these cards, does it sit flush with the top of the unit when inserted? Or does it stick out a bit? I'm just not sure I want something that's going to hang out the top of this PPC.

Thanks in advance.

[Godsongz]

Yes, SD RAM cards will sit flush in your 2200.

Some SDIO cards like the new SD Wi-Fi card will stick out about a half inch :pukeface: I haven't seen one up close but it just sounds... fragile.

[Macguy59]

Yup sits flush. Spring loaded. To insert it just press down on it till it 'locks' in. To remove it, press down until it releases and pops up.

[kagayaki1]

It should also be noted that if you're experiencing an SD card that won't seem to sit flush, it likely is backwards. Of course, when I do that, it won't hardly go in a centimeter. But still, since it was a newbie question, I thought I throw it out there.