sullivanpt
02-24-2006, 07:31 PM
Hi, can someone point me to a solution? I'm sure this has been covered before, but I can't find it...
I'm having trouble getting the Blueooth pairing or PIN to stick between power cycles of the Bluetooth headset.
I have an anycom hs-880 bluetooth headset that was previously paired with a Motorola MPx220. In this configuration, after the first pairing, I just turned on the headset and the phone recognized it was there and enabled the hands free option in calls.
I just switch to a T-Mobile SDA (hump-phone), and re-paired the anycom headset with the new HTC phone. It works fine; however, if I cycle the power on the headset, I get an alert on the phone stating "anycom hs-880 would like to connect" and it requires I reenter the bluetooth PIN. This behavior is very annoying.
Thanks in advance,
I'm having trouble getting the Blueooth pairing or PIN to stick between power cycles of the Bluetooth headset.
I have an anycom hs-880 bluetooth headset that was previously paired with a Motorola MPx220. In this configuration, after the first pairing, I just turned on the headset and the phone recognized it was there and enabled the hands free option in calls.
I just switch to a T-Mobile SDA (hump-phone), and re-paired the anycom headset with the new HTC phone. It works fine; however, if I cycle the power on the headset, I get an alert on the phone stating "anycom hs-880 would like to connect" and it requires I reenter the bluetooth PIN. This behavior is very annoying.
Thanks in advance,