terrypin
12-15-2003, 10:13 AM
Anyone with any feedback about buttonMAX from PocketMax please? I didn't have a good start myself. Installed it last night. Left PPC in its cradle as usual. This morning puzzled to see PPC display was off. Pressing power button did not switch it back on!
Soft reset restored display. But same thing happened when I pressed power button off and then on again - no display.
I was beginning to worry that I'd need a hard reset, which is what happened to me after last attempt to install alarmToday. But after a second soft reset, the power on/off button works normally again.
-------
Also, I didn't like finding my previous 'global' button setup was overridden. Worse, this has not been reflected in Settings|Buttons, which still shows my configuration, not the actual assignment that ButtonMAX has set up.
OK, I have yet to see the benefits, and will persevere.
--
Terry, West Sussex, UK
Using iPAQ 2210 with WM2003.
Soft reset restored display. But same thing happened when I pressed power button off and then on again - no display.
I was beginning to worry that I'd need a hard reset, which is what happened to me after last attempt to install alarmToday. But after a second soft reset, the power on/off button works normally again.
-------
Also, I didn't like finding my previous 'global' button setup was overridden. Worse, this has not been reflected in Settings|Buttons, which still shows my configuration, not the actual assignment that ButtonMAX has set up.
OK, I have yet to see the benefits, and will persevere.
--
Terry, West Sussex, UK
Using iPAQ 2210 with WM2003.